Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Use arborist climbing techniques

KHU-AGR-0035

Australian Equivalent

AHCARB319

Elements

Learning Outcomes

This unit of competency describes the skills and knowledge required to climb trees with ropes, harnesses and specialist equipment using climbing techniques for the purpose of mobility in the canopy of trees to acquire a safe work position. The unit applies to individuals who work in arboriculture under broad direction and take responsibility for their own work. They use discretion and judgement in the selection, allocation and use of available resources and for solving problems. The arboriculture industry requires that all climbing work is undertaken according to preferred industry practices (as oultined in the Companion Volume). No licensing, legislative or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Prepare site and inspect equipment

0035.E1.O1Confirm access to site and scope of works according to workplace procedures

0035.E1.O2Undertake a site-specific job safety analysis (JSA), record and implement control measures according to workplace safety procedures

0035.E1.O3Confirm availability of first aid and rescue personnel, equipment and procedures

0035.E1.O4Conduct pre-operational preparations and safety checks, on ropes, harnesses, tools and equipment

0035.E1.O5Select, check and use personal protective equipment

E2Prepare to access tree

0035.E2.O1Inspect tree to determine efficient safe access route and method through discussion with work team

0035.E2.O2Select and prepare climbing equipment according to manufacturer instructions, work health and safety regulations and industry standards

0035.E2.O3Configure climbing equipment components to form functional tree climbing system appropriate to the access method selected

0035.E2.O4Tie, dress, set and finish climbing knots and hitches according to climbing system requirements

0035.E2.O5Sharpen, prepare and fit climbing spurs and gaffs for dismantling work

0035.E2.O6Conduct pre-climb checks of configured systems to ensure compatibility, safety and function according to climbing system, industry standards and manufacturer instructions

E3Access and work position within tree

0035.E3.O1Select suitable anchor points according to load bearing and access requirements

0035.E3.O2Install low-risk anchor points using throw lines

0035.E3.O3Inspect and test remotely installed anchor points are secure before use

0035.E3.O4Ascend tree and access work positions within tree crown using climbing systems appropriate for work task and tree structure

0035.E3.O5Configure and use components within functional climbing systems for ascending trees and work positioning

0035.E3.O6Access work positions within tree crown by using climbing techniques for both pruning and dismantling work tasks

0035.E3.O7Communicate with work team during operations according to work site and environmental conditions using methods agreed with work team

0035.E3.O8Observe and maintain safe clearance from hazards and climbing and rigging equipment

0035.E3.O9Maintain awareness and clearances for avoiding electrical power lines according to workplace safety procedures

E4Descend from tree

0035.E4.O1Descend tree using climbing equipment in a controlled manner

0035.E4.O2Remove all climbing equipment safely in a controlled manner according to manufacturer instructions

0035.E4.O3Inspect, clean, maintain and store climbing and safety equipment according to manufacturer instructions