Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Remove, replace and program electrical and electronic units and assemblies

KHU-AUT-0110

Australian Equivalent

AURETR026

Elements

Learning Outcomes

This unit describes the performance outcomes required to remove, replace and program electrical and electronic units and assemblies integral to vehicle and machinery controller area network databus (CAN-bus). Electrical and electronic units and assemblies include powertrain control modules, engine and body control modules, and other electronic control modules that may require manufacturer programming procedures. It applies to those working in the automotive service and repair industry. The electrical and electronic units and assemblies include those fitted to agricultural machinery, heavy commercial vehicles, light vehicles, vessels, mobile plant machinery, motorcycles or outdoor power equipment. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Prepare to remove, replace and program electrical and electronic units and assemblies

0110.E1.O1Job requirements are determined from workplace instructions

0110.E1.O2Workplace procedures and manufacturer specifications are accessed and interpreted

0110.E1.O3Removal information is accessed and interpreted from manufacturer and component supplier specifications

0110.E1.O4Hazards associated with the work are identified and risks are managed

0110.E1.O5Tools and equipment are selected and checked for serviceability

E2Remove unit and assembly

0110.E2.O1Unit and assembly are removed using approved methods, tools and equipment and according to manufacturer specifications, workplace procedures and safety requirements

0110.E2.O2Unit and assembly are handled and stored according to manufacturer and component supplier requirements

E3Replace unit and assembly

0110.E3.O1Replacement information is accessed and interpreted from manufacturer and component supplier specifications

0110.E3.O2Unit and assembly are replaced using approved methods, tools and equipment and according to manufacturer specifications and workplace procedures

E4Program unit and assembly

0110.E4.O1Reprogramming options are analysed and those most appropriate are selected

0110.E4.O2Component replacement and programming procedures are carried out according to manufacturer and component supplier specifications

0110.E4.O3Post-replacement testing is carried out to confirm that unit and assembly are operating to manufacturer specifications and that no other problems are present

E5Complete work processes

0110.E5.O1Final inspection is made to ensure work is to workplace expectations and vehicle or machinery is presented ready for use

0110.E5.O2Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected

0110.E5.O3Tools and equipment are checked and stored and any faulty electrical equipment is identified, tagged and isolated according to workplace procedures

0110.E5.O4Workplace documentation is processed according to workplace procedures