Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Remove and replace steering assemblies

KHU-AUT-0396

Australian Equivalent

AURTTD007

Elements

Learning Outcomes

This unit describes the performance outcomes required to remove and replace the steering assemblies of a vehicle. It requires the learner to plan and prepare the task; remove the steering assembly and inspect it and its associated components; replace the steering assembly; and maintain the work area, tools and equipment. It applies to those undertaking a Vocational Education and Training in Schools (VETiS) or pre-vocational qualification as preparation to entering the automotive service and repair or automotive manufacturing industry. The unit is designed for use in a highly supervised context and is not suitable for use in a vocational qualification. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Prepare to remove and replace a steering assembly

0396.E1.O1Safety and environmental requirements are sourced and interpreted

0396.E1.O2Task instruction is interpreted and vehicle steering assembly to be worked on is identified

0396.E1.O3Manufacturer specifications and workplace procedures for removing and replacing steering assembly are sourced and interpreted

0396.E1.O4Potential hazards and risks associated with task are identified and reported to workplace supervisor

0396.E1.O5Tools and equipment required for removing and replacing steering assembly are identified according to manufacturer specifications

E2Remove and inspect steering assembly

0396.E2.O1Tools, equipment and materials are selected and checked prior to use according to manufacturer specifications and safety requirements

0396.E2.O2Vehicle is prepared for steering assembly removal according to workplace procedures and safety and environmental requirements

0396.E2.O3Vehicle steering assembly is removed according to workplace procedures and manufacturer specifications and safety and environmental requirements, and without causing damage to components, tools or equipment

0396.E2.O4Steering assembly components are arranged, identified and inspected according to manufacturer specifications

0396.E2.O5Results of inspecting steering system components are recorded

E3Replace steering assembly

0396.E3.O1Steering assembly components are prepared for assembly

0396.E3.O2Steering assemblies are replaced according to workplace procedures, manufacturer specifications and safety and environmental requirements, and without causing damage to components, tools or equipment

0396.E3.O3Front wheel toe-in is measured and adjusted according to manufacturer specifications

E4Complete work processes

0396.E4.O1Final inspection is made to ensure work meets task instruction and workplace standards, and vehicle steering assembly is presented ready for use or storage according to workplace procedures

0396.E4.O2Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored according to environmental requirements and workplace procedures

0396.E4.O3Tools and equipment are checked and stored according to workplace procedures, or tagged and reported where necessary

0396.E4.O4Workplace documentation is processed according to workplace procedures