Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Remove and replace engine cylinder heads

KHU-AUT-0403

Australian Equivalent

AURTTE009

Elements

Learning Outcomes

This unit describes the performance outcomes required to remove and replace an engine cylinder head. It requires the learner to plan and prepare the task; remove and dismantle the cylinder head, inspect the components, and reassemble and replace the cylinder head; check the engine operation; and maintain the work area, tools and equipment. It applies to those undertaking a Vocational Education and Training in Schools (VETiS) or pre-vocational qualification as preparation to entering the automotive service and repair or automotive manufacturing industry. The unit is designed for use in a highly supervised context and is not suitable for use in a vocational qualification. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Prepare to remove and replace an engine cylinder head

0403.E1.O1Safety and environmental requirements are sourced and interpreted

0403.E1.O2Task instruction is interpreted and engine assembly to be worked on is identified

0403.E1.O3Manufacturer specifications and workplace procedures for engine cylinder head removal and replacement are sourced and interpreted

0403.E1.O4Potential hazards and risks associated with task are identified and reported to workplace supervisor

0403.E1.O5Tools and equipment required for removing and replacing an engine cylinder head are identified according to manufacturer specifications

E2Remove engine cylinder head

0403.E2.O1Tools, equipment and materials are selected and checked according to manufacturer procedures

0403.E2.O2Engine cylinder head is removed according to safety and environmental requirements, and without causing damage to components, tools or equipment

0403.E2.O3Removal procedures are recorded

E3Clean, dismantle and inspect engine cylinder head

0403.E3.O1Cleaning methods and materials are selected and checked according to manufacturer specifications and workplace procedures

0403.E3.O2Engine cylinder head is cleaned according to safety and environmental requirements

0403.E3.O3Engine cylinder head is dismantled without causing damage to components, tools or equipment

0403.E3.O4Engine cylinder head and components are cleaned and arranged for identification

0403.E3.O5Engine cylinder head and components are measured and results compared against manufacturer specifications

0403.E3.O6Engine cylinder head and components inspection results are recorded

E4Reassemble and replace engine cylinder head

0403.E4.O1Engine cylinder head and components are prepared for assembly according to manufacturer specifications and safety requirements

0403.E4.O2Engine cylinder head is assembled according to manufacturer specifications and workplace procedures, and without causing damage to components, tools or equipment

0403.E4.O3Engine cylinder head is replaced onto engine assembly according to manufacturer specifications and workplace procedures, and without causing damage to components, tools or equipment

0403.E4.O4Engine is tested for correct assembly and operation

E5Complete work processes

0403.E5.O1Final inspection is made to ensure work meets task instruction and workplace standards, and engine is presented ready for use or storage according to workplace procedures

0403.E5.O2Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored according to environmental requirements and workplace procedures

0403.E5.O3Tools and equipment are checked and stored in a condition ready for use according to workplace procedures, or tagged and reported where necessary

0403.E5.O4Workplace documentation is processed according to workplace procedures