Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Dismantle and assemble conventional manual transmissions

KHU-AUT-0450

Australian Equivalent

AURTTX012

Elements

Learning Outcomes

This unit describes the performance outcomes required to dismantle and reassemble a conventional manual transmission. It requires the learner to plan and prepare the task; dismantle the transmission and inspect the components; reassemble the transmission and check the transmission operation; and maintain the work area, tools and equipment. It applies to those undertaking a Vocational Education and Training in Schools (VETiS) or pre-vocational qualification as preparation to entering the automotive service and repair or automotive manufacturing industry. The unit is designed for use in a highly supervised context and is not suitable for use in a vocational qualification. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Prepare to dismantle and assemble conventional manual transmission

0450.E1.O1Safety and environmental requirements are sourced and interpreted

0450.E1.O2Task instruction is interpreted and transmission to be worked on is identified

0450.E1.O3Manufacturer specifications and workplace procedures for conventional manual transmission dismantle and assembly are sourced and interpreted

0450.E1.O4Potential hazards and risks associated with task are identified and reported to workplace supervisor

0450.E1.O5Tools and equipment required for conventional manual transmission dismantle and reassembly are identified according to manufacturer specifications

E2Dismantle a conventional manual transmission

0450.E2.O1Tools, equipment and materials are selected and checked prior to use according to manufacturer specifications and safety requirements

0450.E2.O2Manual transmission is dismantled according to workplace procedures and safety and environmental requirements, and without causing damage to components, tools or equipment

0450.E2.O3Transmission components are cleaned and arranged for identification according to workplace procedures

E3Inspect and identify gears and bearings

0450.E3.O1Measuring equipment and tools are selected and checked according to manufacturer specifications and workplace safety procedures

0450.E3.O2Gears and bearings are inspected and measured, and measurements are compared against manufacturer specifications

0450.E3.O3Transmission bearing information is sourced and interpreted, and bearing type and associated loads are identified

0450.E3.O4Gear types are identified and gear ratios calculated and recorded

E4Inspect components and re-assemble transmission

0450.E4.O1Transmission seals, sealants and gasket information is sourced and interpreted; and seals, sealants and gaskets are identified

0450.E4.O2Transmission component’s inspection results are recorded

0450.E4.O3Transmission components are prepared for assembly according to manufacturer specifications and safety and environmental requirements

0450.E4.O4Transmission is assembled according to manufacturer specifications and requirements

E5Complete work processes

0450.E5.O1Final inspection is made to ensure work meets task instruction and workplace standards, and conventional manual transmission is presented ready for use or storage according to workplace procedures

0450.E5.O2Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored according to environmental requirements and workplace procedures

0450.E5.O3Tools and equipment are checked and stored according to workplace procedures, or tagged and reported where necessary

0450.E5.O4Workplace documentation is processed according to workplace procedures