Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Cut and process vehicle and machinery flat laminated glass

KHU-AUT-0478

Australian Equivalent

AURVTG008

Elements

Learning Outcomes

This unit describes the performance outcomes required to measure, mark, cut and process flat laminated glass for installation into vehicles and machinery. It involves preparing for the task, selecting and using specialist tools and equipment, producing templates according to size, cutting flat laminated glass and finishing glass edges to given specifications, and completing workplace processes and documentation. It applies to those working in the automotive glazing service and repair industry. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Prepare to cut and process flat laminated glass

0478.E1.O1Job requirements are determined from workplace instructions

0478.E1.O2Information is accessed and interpreted from laminated glass supplier specifications

0478.E1.O3Laminated glass is sourced according to work order and job specifications and checked for quality

0478.E1.O4Hazards associated with the work are identified and risks are managed

0478.E1.O5Glass cutting equipment and personal protective equipment (PPE) are selected and checked for serviceability

0478.E1.O6Work is planned to minimise off-cuts and use time efficiently

E2Fabricate templates and patterns

0478.E2.O1Accurate measurements are taken or checked to prepare templates and patterns

0478.E2.O2Suitable materials and equipment are used to fabricate templates and patterns

0478.E2.O3Template and pattern are marked out and fabricated according to workplace instructions, workplace procedures, and safety and environmental requirements

E3Process glass

0478.E3.O1Glass is measured, marked and cut out according to measurements, template and pattern, and safety and environmental requirements

0478.E3.O2Glass cutting is completed according to workplace procedures, and safety and environmental requirements, and without causing damage to glass being cut

0478.E3.O3Glass edges are arris or bevel edged according to workplace procedures, and safety and environmental requirements, and without causing damage to glass

E4Complete work processes

0478.E4.O1Final inspection is made to ensure work meets workplace expectations

0478.E4.O2Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored

0478.E4.O3Tools and equipment are checked, reported if faulty, and stored according to workplace procedures

0478.E4.O4Workplace documentation is processed according to workplace procedures