Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Trim vehicle components

KHU-AUT-0567

Australian Equivalent

AURVTT004

Elements

Learning Outcomes

This unit describes the performance outcomes required to calculate, mark, cut, sew and attach trim material to vehicle components. It involves preparing for the task, selecting and using specialist tools and equipment, selecting trim materials and checking their quality, developing material patterns, fabricating, assembling and attaching trim to components and checking trim against specifications, and completing workplace processes and documentation. It applies to those working in the automotive and marine trimming industry. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Prepare for work

0567.E1.O1Job requirements are determined from workplace instructions

0567.E1.O2Trim materials are selected and inspected for quality

0567.E1.O3Safety data sheets (SDS) are sourced and interpreted

0567.E1.O4Hazards associated with the work are identified and risks are managed

0567.E1.O5Trim tools and equipment and personal protective equipment (PPE) are selected and checked for serviceability

0567.E1.O6Work is planned to minimise waste and use time efficiently

E2Measure, mark, cut and fabricate trim

0567.E2.O1Material patterns are developed and prepared for use

0567.E2.O2Trim materials are measured, marked and cut according to workplace instructions and prepared pattern

0567.E2.O3Trimming tools and equipment are used according to workplace procedures and safety and environmental requirements

0567.E2.O4Trim is fabricated according to work instructions and job requirements

E3Attach trim

0567.E3.O1Trim materials are fitted and checked for alignment, appearance and quality according to job specifications and workplace instructions

0567.E3.O2Trim materials are attached to vehicle component and checked against specifications

E4Complete work processes

0567.E4.O1Final inspection is made to ensure work meets workplace expectations and component is presented ready for use

0567.E4.O2Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable materials is collected and stored

0567.E4.O3Tools and equipment are checked, reported if faulty, and stored according to workplace procedures

0567.E4.O4Workplace documentation is processed according to workplace procedures