Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Fabricate and fit marine covers

KHU-AUT-0575

Australian Equivalent

AURVTT014

Elements

Learning Outcomes

This unit describes the performance outcomes required to fabricate and fit covers for different marine applications. It involves preparing for the task, selecting and using specialist tools and equipment, selecting materials and checking their quality, following manufacturer and customer instructions, inspecting final work, and completing workplace processes and documentation. It applies to those working in the marine trimming industry. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Prepare to fabricate marine covers

0575.E1.O1Job requirements are determined from workplace instructions

0575.E1.O2Materials are selected and inspected for quality, and quantities are calculated

0575.E1.O3Hazards associated with the work are identified and risks are managed

0575.E1.O4Tools and equipment, including personal protective equipment (PPE), are selected for appropriate fabrication methods and checked for serviceability

0575.E1.O5Work area is prepared and work is planned to minimise waste and use time efficiently

E2Measure, mark out and cut materials

0575.E2.O1Templates and specialist tools and equipment are selected and used according to safety and environmental requirements

0575.E2.O2Materials are marked out and cut according to patterns, templates workplace instructions, manufacturer specifications and fitting requirements

E3Fabricate, fit and fasten marine covers

0575.E3.O1Marine covers are fabricated and assembled according to job requirements and workplace instructions

0575.E3.O2Marine covers are fitted and fastened without causing damage to vehicle or components

0575.E3.O3Fitted marine covers are checked for alignment and quality according to job requirements, workplace procedures and manufacturer specifications

E4Complete work processes

0575.E4.O1Final inspection is made to ensure work meets workplace expectations and component is presented ready for use

0575.E4.O2Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored

0575.E4.O3Tools and equipment are checked, reported if faulty, and stored according to workplace procedures

0575.E4.O4Workplace documentation is processed according to workplace procedures