Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Fabricate and install canvas products for automotive and marine components

KHU-AUT-0576

Australian Equivalent

AURVTT015

Elements

Learning Outcomes

This unit describes the performance outcomes required to fabricate and install canvas covers and products in automotive and marine components. It involves preparing for the task, selecting and using specialist tools and equipment, selecting materials and checking their quality, measuring and cutting canvas products, and completing workplace processes and documentation. It applies to those working in the automotive and marine trimming industry. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Prepare to fabricate canvas products

0576.E1.O1Job requirements are determined from workplace instructions

0576.E1.O2Canvas materials are selected and inspected for quality and quantities are calculated

0576.E1.O3Hazards associated with the work are identified and risks are managed

0576.E1.O4Tools and equipment, including personal protective equipment (PPE), are selected for appropriate fabrication methods and checked for serviceability

0576.E1.O5Work area is prepared and work is planned to minimise waste and use time efficiently

E2Cut, fabricate and install canvas covers and products

0576.E2.O1Materials are measured, marked out and cut according to job requirements and workplace instructions

0576.E2.O2Canvas products are fabricated using canvas sewing techniques and according to job requirements, workplace procedures, and safety and environmental requirements

0576.E2.O3Canvas products are assembled according to workplace procedures and safety and environmental requirements

0576.E2.O4Installation methods for canvas products are identified and applied according to work instructions

E3Complete work processes

0576.E3.O1Final inspection is made to ensure work meets workplace expectations and component is presented ready for use

0576.E3.O2Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored

0576.E3.O3Tools and equipment are checked, reported if faulty, and stored according to workplace procedures

0576.E3.O4Workplace documentation is processed according to workplace procedures