Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Fabricate and install automotive and marine floor coverings

KHU-AUT-0577

Australian Equivalent

AURVTT017

Elements

Learning Outcomes

This unit describes the performance outcomes required to measure, mark out, and cut, and fabricate and install automotive or marine floor coverings. It involves preparing for the task, selecting and using specialist tools and equipment, selecting materials and checking their quality, following manufacturer and customer instructions, and completing workplace processes and documentation. It applies to those working in the automotive and marine trimming service and repair industry. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Prepare for fabrication of floor coverings

0577.E1.O1Job requirements are determined from workplace instructions

0577.E1.O2Fabrication methods and materials are selected and inspected for quality and quantities are calculated

0577.E1.O3Hazards associated with the work are identified and risks are managed

0577.E1.O4Tools and equipment, including personal protective equipment (PPE), are selected and checked for serviceability

0577.E1.O5Work is planned to minimise waste and use time efficiently

E2Measure, fabricate and install floor coverings

0577.E2.O1Work area is prepared and fabrication tools and equipment are set up for job requirement

0577.E2.O2Materials are measured, marked out and cut according to floor covering specifications and patterns, workplace procedures, and safety and environmental requirements

0577.E2.O3Floor coverings are fabricated and fabrication process is monitored to ensure specifications, customer requirements, and workplace procedures are met

0577.E2.O4Defects, quality issues and non-conformances are reported to authorised personnel according to workplace procedures

0577.E2.O5Installation and fitting of floor coverings, insulation and fastenings are completed according to workplace procedures and job requirements

E3Complete work processes

0577.E3.O1Final inspection is made to ensure work meets workplace expectations and vehicle is presented ready for use

0577.E3.O2Work area is cleaned, waste and non-recyclable materials are disposed of, and recyclable material is collected and stored

0577.E3.O3Tools and equipment are checked, reported if faulty, and stored according to workplace procedures

0577.E3.O4Workplace documentation is processed according to workplace procedures