Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Carry out tungsten inert gas welding

KHU-AUT-0590

Australian Equivalent

AURVTW104

Elements

Learning Outcomes

This unit describes the skills and knowledge required to carry out welding operations using tungsten inert gas (TIG) welding. It involves preparing for the task, selecting and using TIG welding equipment, setting gas flow pressures and welder settings, selecting and using suitable personal protective equipment (PPE), performing welding to given specifications, inspecting and testing weld quality, and completing workplace processes and documentation. This unit applies to those working in the automotive service and repair industry. No licensing, legislative, regulatory or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Plan and prepare to weld

0590.E1.O1Determine job requirements from workplace instructions

0590.E1.O2Access and interpret welding information

0590.E1.O3Identify hazards associated with the work and manage risks

0590.E1.O4Select and check tools and equipment for serviceability

0590.E1.O5Prepare work area and plan work to carry out TIG welding, minimise waste, and use time efficiently

E2Weld materials using TIG welder

0590.E2.O1Prepare, set up and adjust TIG welding equipment for specific welding job requirement

0590.E2.O2Use TIG welding equipment according to manufacturer operating procedures and safety and environmental requirements

0590.E2.O3Conduct weld test runs according to workplace instructions and weld specifications

0590.E2.O4Weld materials using standard or inverter TIG process to industry standards

E3Check welds

0590.E3.O1Clean welds using required tools and techniques and according to workplace instructions

0590.E3.O2Check and confirm weld specifications and quality requirements by non-destructive inspection

0590.E3.O3Identify weld defects, prepare for re-welding as required, and notify required personnel

E4Complete work processes

0590.E4.O1Conduct final inspection according to workplace procedures and confirm vehicle is ready for use

0590.E4.O2Clear work area and dispose of or recycle materials according to workplace procedures

0590.E4.O3Process workplace documentation according to workplace procedures