Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Frame and fit wet area fixtures

KHU-CON-0116

Australian Equivalent

CPCCCA3012

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to install supporting framework for fixtures and flashings for wet area construction of a bath, shower base, and prepare for wet area linings, meeting all relevant requirements of the National Construction Code (NCC), Australian Standards, work health and safety (WHS), and Commonwealth and state or territory legislation. The unit includes setting out, cutting and fabrication of frames and installation of frames in bathroom, laundry, shower, toilet and en suite wet areas. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements appl

Elements & Learning Outcomes

E1Plan and prepare.

0116.E1.O1Read and interpret work instructions and plan sequence of work.

0116.E1.O2Plan all work to comply with laws and regulations, the National Construction Code (NCC), Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, workplace requirements, drawings and specifications.

0116.E1.O3Select tools and equipment, check for serviceability and report any faults.

0116.E1.O4Select and use personal protective equipment (PPE) as required for each stage of the task.

0116.E1.O5Inspect work site, locate services, assess hazards and apply risk controls, including required signage and barricades.

0116.E1.O6Select materials required for task, calculate quantities, handle safely and prepare and position ready for use.

E2Construct frames for bath installation.

0116.E2.O1Set out noggings and housings for bath fitments and fixtures.

0116.E2.O2Notch studs to height and level for required depth to receive lip of bath.

0116.E2.O3Construct support to front edge of bath to height and level.

0116.E2.O4Fit and fix noggings and jack studs flush for lining.

E3Construct frames for shower base installation.

0116.E3.O1Set out location of shower base, noggings and housings for shower fitments and fixtures.

0116.E3.O2Mark and notch all plates and studs to required depth to receive shower base.

0116.E3.O3Fit and fix noggings and jack studs flush to wall face for lining.

0116.E3.O4Install corner flashing.

E4Clean up.

0116.E4.O1Clean up, meeting all legislative and workplace requirements for safety, waste disposal and materials handling.

0116.E4.O2Check, maintain and store tools and equipment and report any faults.