Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Work safely around electrical sources, services and assets

KHU-CON-0142

Australian Equivalent

CPCCCM3003

Elements

Learning Outcomes

This unit of competency specifies the outcomes required to ensure the safety of personnel and equipment when working with or operating plant while in close proximity to electrical sources, underground and overhead services, and assets. The unit supports construction workers working on powered construction sites who must check and confirm the location of electrical sources, underground and overhead services, and assets before commencing work. It applies to residential and commercial work sites. No licensing, legislative, regulatory, or certification requirements apply to this unit of competency at the time of endorsement.

Elements & Learning Outcomes

E1Plan and prepare.

0142.E1.O1Work instructions, including plans, specifications, environmental and quality requirements, and operational details, are obtained, confirmed with relevant personnel, and applied to planning.

0142.E1.O2Health and safety requirements are identified and applied to planning.

0142.E1.O3Plant, tools and equipment are selected to carry out tasks according to job requirements, checked for serviceability, and any faults are rectified or reported prior to starting work.

E2Apply safe work practices.

0142.E2.O1Relevant authorities are contacted to identify type and location of electrical sources, underground or overhead services, and assets.

0142.E2.O2Plant is positioned according to safe work method statement (SWMS).

0142.E2.O3Plant operation procedures are followed to comply with SWMS.

0142.E2.O4Work is conducted in or around the electrical source, service or asset according to SWMS.

0142.E2.O5On completion of work, personnel, plant and equipment are retracted from powered area following SWMS.

E3Clean up.

0142.E3.O1Work area is cleared and materials disposed of, reused or recycled according to legislation, regulations, codes of practice and job specifications.

0142.E3.O2Plant, tools and equipment are cleaned, checked, maintained and stored according to manufacturer recommendations and standard work practices.

0142.E3.O3Work completion procedures are followed and relevant personnel are notified that work is finished.