Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Carry out concreting to simple forms

KHU-CON-0145

Australian Equivalent

CPCCCO2013

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to safely install formwork, reinforcement and place and finish concrete for the construction of minor slabs, pathways and other minor works to a specified design finish, meeting all relevant requirements of the National Construction Code (NCC), Australian Standards, work health and safety (WHS), and Commonwealth and state or territory legislation. The unit is suitable for those with basic skills and knowledge undertaking routine work tasks under the direction of more experienced workers. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification

Elements & Learning Outcomes

E1Plan and prepare.

0145.E1.O1Read and interpret work instructions and plan sequence of work.

0145.E1.O2Plan all work to comply with laws and regulations, the National Construction Code (NCC), Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, workplace requirements, drawings and specifications.

0145.E1.O3Select tools and equipment, check for serviceability and report any faults.

0145.E1.O4Select and use personal protective equipment (PPE) for each part of the task.

0145.E1.O5Inspect work site, locate services, assess hazards and apply risk controls, including required signage and barricades.

0145.E1.O6Select materials required for task, calculate quantities, handle safely and prepare and position ready for use.

E2Erect simple formwork.

0145.E2.O1Prepare substrate.

0145.E2.O2Review formwork design from drawings.

0145.E2.O3Erect formwork.

0145.E2.O4Install vapour barrier.

E3Place and tie reinforcement.

0145.E3.O1Handle, cut and position reinforcing components.

0145.E3.O2Position reinforcing bars and mesh.

0145.E3.O3Position bar chairs and spacers with minimum edge cover.

E4Place concrete.

0145.E4.O1Clean formwork or excavation of excess material and debris before concrete placement.

0145.E4.O2Transport concrete by wheelbarrow.

0145.E4.O3Place concrete in formwork to specified depth.

0145.E4.O4Screed concrete to the alignment of formwork and specified datums.

0145.E4.O5Finish surface of concrete to specifications.

E5Strip simple formwork.

0145.E5.O1Denail timber components following stripping of formwork.

0145.E5.O2Clean and stack components and store for reuse or bundle for removal.

0145.E5.O3Remove formwork components from site.

E6Clean up.

0145.E6.O1Clean up, meeting all legislative and workplace requirements for safety, waste disposal, materials handling and protection of the environment.

0145.E6.O2Check, maintain and store tools and equipment and report any faults.