Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Design and set out stairs

KHU-CON-0186

Australian Equivalent

CPCCJS3011

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to design and set-out materials for the manufacturing of stairs, meeting all relevant requirements of the National Construction Code (NCC), Australian Standards, work health and safety (WHS), and Commonwealth and state or territory legislation. The unit includes the design and set-out of components for straight flighted stairs with cut or closed stringers. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Plan and prepare.

0186.E1.O1Read and interpret work instructions and plan sequence of work.

0186.E1.O2Plan all work to comply with laws and regulations, the National Construction Code (NCC), Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, workplace requirements, drawings and specifications.

0186.E1.O3Select tools and equipment, check for serviceability and report any faults.

0186.E1.O4Select and use personal protective equipment (PPE) for each part of the task.

E2Prepare stair design.

0186.E2.O1Determine rise and going for steps and calculate lengths of stringers in compliance with NCC requirements and total rise of the stair.

0186.E2.O2Calculate number of treads from number of rises and other requirements.

0186.E2.O3Take and record landing measurements and requirements.

0186.E2.O4Determine specifications for winders and incorporate into stair design.

0186.E2.O5Design and draw stair and stair components and check for accuracy and completeness.

E3Prepare materials for setting out.

0186.E3.O1Document material requirements for stair components and prepare detailed cutting list.

0186.E3.O2Select, check and prepare materials for set out.

0186.E3.O3Set out joins for laminated sections.

E4Set out stringers for a stair.

0186.E4.O1Prepare steel square or pitch board to stair pitch set-out.

0186.E4.O2Set out stringers and mark for junctions, newel posts, treads and risers.

E5Set out newel posts.

0186.E5.O1Mark floor to landing height relationships with allowances for floor discrepancies on newel posts.

0186.E5.O2Set out newel posts to show positions of stringers, treads, flooring, joists, bearers and handrails.

0186.E5.O3Mark locations for housings on newel posts.

E6Set out component parts.

0186.E6.O1Determine lengths and bevels from stringer and newel post set-outs.

0186.E6.O2Set out component parts to respective lengths and bevels.

E7Clean up.

0186.E7.O1Clean up, meeting all legislative and workplace requirements for safety, waste disposal, materials handling and protection of the environment.

0186.E7.O2Check, maintain and store tools and equipment and report any faults.