Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Finish concrete

KHU-CON-0213

Australian Equivalent

CPCCON3042

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to finish placed and screeded concrete surfaces to specification. It requires using manual and mechanical finishing techniques including edge finishing. A person who has achieved this unit of competency would be expected to take responsibility for organising and completing these tasks with a high degree of self-direction. Licensing, legislative, regulatory or certification requirements apply to this unit of competency in some states and territories. For further information, check with the relevant regulatory authority. Completion of the general construction induction training program, specified in the Safe Work Australia model Code of Practice: Construction Work , is required by anyone carrying out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement.

Elements & Learning Outcomes

E1Plan and prepare to finish concrete.

0213.E1.O1Interpret specifications for concrete finishing and clarify requirements with relevant persons.

0213.E1.O2Plan work tasks to comply with relevant legislation, regulations, standards, codes, work health and safety (WHS), environmental and workplace requirements.

0213.E1.O3Select and fit required personal protective equipment (PPE).

0213.E1.O4Inspect work site, assess hazards and apply risk controls, including required signage and barricades.

0213.E1.O5Select plant, tools and equipment, check for serviceability and rectify or report any faults.

E2Apply concrete finishing techniques.

0213.E2.O1Leave concrete untouched until bleed water has come to the surface and evaporated.

0213.E2.O2Assess concrete surface during curing process and maintain level surface to allow manual and mechanical trowelling to be applied.

0213.E2.O3Assess strength of setting concrete using basic thumb test to ensure weight of mechanical trowel and operator can be accommodated.

0213.E2.O4Apply mechanical trowelling in multiple overlapping lines to consolidate and densify the setting concrete surface.

0213.E2.O5Install jointing system, finish edges, and trowel concrete to specifications.

0213.E2.O6Finish concrete and check compliance with specifications and workplace requirements.

E3Clean up.

0213.E3.O1Clear work area and dispose of, reuse or recycle materials in accordance with regulatory and workplace requirements.

0213.E3.O2Clean, check, maintain and store tools and equipment in accordance with manufacturer and workplace requirements.