Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Cut and fix paper-faced cornices

KHU-CON-0243

Australian Equivalent

CPCCPB3012

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to measure, cut and fix paper-faced cornices. A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without close supervision. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of unit CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Plan and prepare.

0243.E1.O1Read and interpret work instructions and plan sequence of work.

0243.E1.O2Plan all work to comply with laws and regulations, Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, and workplace requirements.

0243.E1.O3Select and use personal protective equipment (PPE) for each stage of the task.

0243.E1.O4Inspect work site, assess hazards and apply risk controls, including required signage and barricades.

0243.E1.O5Select tools and equipment, check for serviceability and report any faults that may affect the safe operation of the equipment, tag equipment and set aside.

E2Plan, measure and cut cornices.

0243.E2.O1Select specified style of paper-faced cornice.

0243.E2.O2Plan requirements to enable safe work at heights.

0243.E2.O3Measure and record cornice lengths for each wall/ceiling.

0243.E2.O4Handle cornice following safe manual handling procedures.

0243.E2.O5Use recorded measurements to select cornice materials, allowing for mitre requirements.

0243.E2.O6Cut cornice using safe manual handling procedures.

E3Fix cornice.

0243.E3.O1Prepare cornice adhesive to manufacturers' specifications, adjusting consistency of mix to suit selected hand or mechanical application method.

0243.E3.O2Apply minimum 10mm bead of adhesive to cornice.

0243.E3.O3Fit cornice using methods of temporary or permanent fixing to hold the cornice in place at the wall and ceiling junction.

0243.E3.O4Apply adhesive to mitres.

E4Finish work.

0243.E4.O1Remove adhesive from cornice faces.

0243.E4.O2Fill and sand/polish mitres and joints.

0243.E4.O3Remove temporary fixings and fill holes.

E5Clean up.

0243.E5.O1Clear work area and dispose of, reuse or recycle materials.

0243.E5.O2Clean, check, maintain and store tools and equipment in accordance with manufacturers’ specifications.