Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Use vacuum and electric sanding equipment to finish plaster work

KHU-CON-0248

Australian Equivalent

CPCCPB3018

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to machine sand plaster joints in walls and ceilings. A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without close supervision. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of unit CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Plan and prepare.

0248.E1.O1Read and interpret work instructions, determine required standard of finish, and plan sequence of work.

0248.E1.O2Plan all work to comply with laws and regulations, Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, and workplace requirements.

0248.E1.O3Select and use related personal protective equipment (PPE) for each stage of the task.

0248.E1.O4Inspect work site, assess hazards and apply risk controls, including required signage and barricades.

0248.E1.O5Select tools and equipment, check for serviceability and report any faults that may affect the safe operation of the equipment, tag equipment and set aside.

E2Mechanically sand joints and screw heads.

0248.E2.O1Select sanding grit to minimise liner paper damage, set up sanding equipment, leads and dust protection.

0248.E2.O2Use stance and posture to hold and manipulate sanding equipment to minimise manual handling risks.

0248.E2.O3Complete sanding joints and screw heads to required standard of finish, taking care to not over-sand.

0248.E2.O4Inspect completed sanding work for quality.

0248.E2.O5Report any sand-through areas.

0248.E2.O6Brush down sanded area.

E3Clean up.

0248.E3.O1Clear work area and dispose of, reuse or recycle materials.

0248.E3.O2Clean, check, maintain and store tools and equipment in accordance with manufacturers’ specifications.