Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Match, mitre and install cast ornamental cornices

KHU-CON-0250

Australian Equivalent

CPCCPB3020

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to measure, match, cut and fix cast ornamental cornices. A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without close supervision. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Plan and prepare.

0250.E1.O1Read and interpret work instructions and plan sequence of work.

0250.E1.O2Plan all work to comply with laws and regulations, Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, and workplace requirements.

0250.E1.O3Select and use personal protective equipment (PPE) for each stage of the task.

0250.E1.O4Inspect work site, assess hazards and apply risk controls, including required signage and barricades.

0250.E1.O5Select tools and equipment, check for serviceability and report any faults that may affect the safe operation of the equipment, tag equipment and set aside.

0250.E1.O6Select materials required for task, calculate quantities, handle safely and prepare and position ready for use.

E2Plan and measure for cornice work.

0250.E2.O1Select specified style of cornice.

0250.E2.O2Plan requirements to enable safe work at heights.

0250.E2.O3Measure and record cornice lengths for each wall/ceiling.

0250.E2.O4Handle cornice following safe manual handling procedures.

0250.E2.O5Use recorded measurements to select cornice materials, allowing for mitre requirements.

E3Cut cornice lengths.

0250.E3.O1Determine and mark matching points for ornamental cornice.

0250.E3.O2Cut cornice using safe manual handling procedures.

0250.E3.O3Check pattern match.

E4Fix cornice.

0250.E4.O1Prepare cornice adhesive to manufacturers' specifications, adjusting consistency of mix to suit selected hand or mechanical application method.

0250.E4.O2Apply minimum 10mm bead of adhesive to cornice.

0250.E4.O3Fit cornice using methods of temporary or permanent fixing to hold the cornice in place at the wall and ceiling junction.

0250.E4.O4Apply adhesive to mitres.

E5Finish work.

0250.E5.O1Remove excess cornice adhesive.

0250.E5.O2Fill and smooth joins, pattern matches and junctions.

0250.E5.O3Remove temporary fixings and supports and fill holes.

E6Clean up.

0250.E6.O1Clear work area and dispose of, reuse or recycle materials.

0250.E6.O2Clean, check, maintain and store tools and equipment in accordance with manufacturers’ specifications.