Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Use mechanical jointing equipment to finish joints

KHU-CON-0252

Australian Equivalent

CPCCPB3022

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to use mechanical taping and filling tools to finish joints. A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without close supervision. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Plan and prepare.

0252.E1.O1Read and interpret work instructions and plan sequence of work.

0252.E1.O2Plan all work to comply with laws and regulations, Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, and workplace requirements.

0252.E1.O3Select and use personal protective equipment (PPE) for each stage of the task.

0252.E1.O4Inspect work site, assess hazards and apply risk controls.

0252.E1.O5Select tools and equipment, check for serviceability and report any faults that may affect the safe operation of the equipment, tag equipment and set aside.

0252.E1.O6Select materials required for task, including compound, calculate quantities, handle safely and prepare and position ready for use.

E2Prepare for work.

0252.E2.O1Locate penetrations and openings and erect barriers at identified points.

0252.E2.O2Clear and clean floor.

0252.E2.O3Mix compound to required consistency using safe work methods when mechanically mixing compound.

0252.E2.O4Adjust tool handle to required length.

0252.E2.O5Maintain correct posture during operations and rotate tasks in accordance with work site risk assessment.

E3Reinforce and fill joints using mechanical filling and taping equipment.

0252.E3.O1Tape and fill joints with minimum compound loaded for immediate use, so that they are smooth, even and reinforced to form a seamless appearance.

0252.E3.O2Tape and fill internal angles to achieve a perceived smooth and even appearance, ensuring there is sufficient compound under the tape.

0252.E3.O3Complete flat joints.

E4Finish joints mechanically.

0252.E4.O1Complete finishing joints with minimum compound loaded for immediate use.

0252.E4.O2Finish joints to produce a smooth and even seamless appearance, ensuring that the box crown is set correctly.

0252.E4.O3Maintain correct posture during operations and rotate tasks in accordance with work site risk assessment.

E5Clean up.

0252.E5.O1Clear work area and dispose of, reuse or recycle materials.

0252.E5.O2Clean, check, maintain and store tools and equipment in accordance with manufacturers’ specifications.