Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Use computer-controlled static machinery to produce stone components

KHU-CON-0343

Australian Equivalent

CPCCST3009

Elements

Learning Outcomes

This unit specifies the skills and knowledge required to produce hard and soft stone components using computer-controlled machines. It includes curved and straight moulds, levels and cuts. This unit applies to stonemasons who work independently, in a team or under supervision and operate machinery relating to stonemasonry work in a workshop setting, on a new or existing structure. A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without needing close supervision. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements appl

Elements & Learning Outcomes

E1Plan and prepare.

0343.E1.O1Read, interpret and apply static machinery requirements from work instructions, job requirements and machine operator instructions.

0343.E1.O2Follow relevant information from workplace procedures, workplace safety and environmental documentation.

0343.E1.O3Determine job priorities and sequence job tasks in consultation with others on site.

0343.E1.O4Identify potential hazards and implement control measures.

0343.E1.O5Select and check condition of plant, equipment and tools and report damage or faults to relevant person.

0343.E1.O6Check conformity of materials against job requirements.

E2Carry out data input.

0343.E2.O1Select, fit correctly and use personal protective equipment (PPE) appropriate for job.

0343.E2.O2Determine and state programming terms, methods, limits and data storage capacity consistent with job requirements.

0343.E2.O3Write, enter and edit program to produce straight and circular movements, compensating for tool profiles.

E3Transfer program to machine control.

0343.E3.O1Identify and record methods of transferring program into machine memory.

0343.E3.O2Load program into machine memory using appropriate techniques to meet machine and job requirements.

E4Operate loaded program to control machine.

0343.E4.O1Conduct a program dry run in simulation mode to test alarm setting and edit using control station.

0343.E4.O2Take precautions to ensure production of silica dust is minimised.

0343.E4.O3Produce specific work pieces using automatic mode.

E5Clean up.

0343.E5.O1Clear the work area, and dispose of, reuse or recycle materials following workplace and environmental requirements.

0343.E5.O2Clean tools and equipment, check for serviceability and report damage or faults.

0343.E5.O3Store and secure tools and equipment following workplace procedures.