Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Apply gilding to stone

KHU-CON-0349

Australian Equivalent

CPCCST3015

Elements

Learning Outcomes

This unit specifies the skills and knowledge required to apply gilding to letters, monograms and insignias carved into stone surfaces. This unit applies to stonemasons who work independently or in a team to apply gilding to stonework in a workshop setting, on a new or existing structure. A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without needing close supervision. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Plan and prepare.

0349.E1.O1Read, interpret and apply gilding to stone requirements from job instructions, standards and codes.

0349.E1.O2Follow relevant information from workplace procedures, workplace safety and environmental documentation.

0349.E1.O3Determine job priorities and sequence job tasks in consultation with others on site.

0349.E1.O4Identify potential hazards and determine and implement control measures.

0349.E1.O5Select and check condition of equipment and tools and report damage or faults to relevant person.

0349.E1.O6Check conformity of materials against the job requirements.

E2Apply gilding.

0349.E2.O1Select, fit correctly and use personal protective equipment (PPE) appropriate for job.

0349.E2.O2Prepare stone surface and pre-cut lettering and shapes to job specifications.

0349.E2.O3Mix and apply specific colour to stone surface ensuring size is contained within the lettering or shape.

0349.E2.O4Determine potential shrinkage of gilding material and cut gilding accordingly.

0349.E2.O5Check sized surface for stickiness and apply gilding material.

0349.E2.O6Trim and remove excess gilding at edges of lettering or shape.

0349.E2.O7Burnish gilding material and ensure loose particles are removed.

0349.E2.O8Select and apply cleaning products and cleaning procedure to surrounding area.

E3Clean up

0349.E3.O1Clear the work area, and dispose of, reuse or recycle materials following workplace and environmental requirements.

0349.E3.O2Clean tools and equipment, check for serviceability and report damage or faults.

0349.E3.O3Store and secure tools and equipment following workplace procedures.