Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Inlay lead to stone

KHU-CON-0352

Australian Equivalent

CPCCST3018

Elements

Learning Outcomes

This unit specifies the skills and knowledge required to inlay lead to letters or shapes carved into stone. This unit applies to stonemasons who work independently or in a team to inlay lead relating to stonemasonry work in a workshop setting, on a new or existing structure. A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without needing close supervision. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements apply to this unit at the time of publication.

Elements & Learning Outcomes

E1Plan and prepare.

0352.E1.O1Read, interpret and apply lead inlaying requirements from work instructions, job requirements, standards and codes.

0352.E1.O2Follow relevant information from workplace procedures, workplace safety and environmental documentation.

0352.E1.O3Determine job priorities and sequence job tasks in consultation with others on site.

0352.E1.O4Identify potential hazards and determine and implement control measures.

0352.E1.O5Select and check condition of equipment and tools and report damage or faults to relevant person.

E2Perform lead inlay to lettering

0352.E2.O1Select, fit correctly and use personal protective equipment (PPE) appropriate for job.

0352.E2.O2Prepare base of lettering to key lead.

0352.E2.O3Handle and prepare lead safely and work in a well-ventilated area.

0352.E2.O4Cut lead strips to suit incised letters or shapes and press into position.

0352.E2.O5Beat lead strips into carved letters or shapes without damage to stone face.

0352.E2.O6Rasp and rub lead to an even flat or raised finish with clean edges.

0352.E2.O7Finish and polish lead inlay using fine abrasive products.

E3Clean up.

0352.E3.O1Clear the work area, and dispose of, reuse or recycle materials following workplace and environmental requirements.

0352.E3.O2Clean tools and equipment, check for serviceability and report damage or faults.

0352.E3.O3Store and secure tools and equipment following workplace procedures.