Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Carry out profile work

KHU-CON-0356

Australian Equivalent

CPCCST3022

Elements

Learning Outcomes

This unit specifies the skills and knowledge required to carry out profile work on the edges of soft and hard stone using profiling machinery, equipment and tools. It includes producing templates in various materials and transferring patterns onto stone. This unit applies to stonemasons who work independently or in a team and operate machinery relating to stonemasonry profile work in a workshop setting, on a new or existing structure. A person working at this level would be expected to take responsibility for organising and completing tasks assigned to them without needing close supervision. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No li

Elements & Learning Outcomes

E1Plan and prepare.

0356.E1.O1Read, interpret and apply profile work requirements from job and work instructions, standards and codes.

0356.E1.O2Follow relevant information from workplace procedures, workplace safety and environmental documentation.

0356.E1.O3Select tools and equipment and check for damage and faults.

0356.E1.O4Check materials comply with job requirements and place in position ready for the work.

E2Develop patterns.

0356.E2.O1Select, fit correctly and use personal protective equipment (PPE) appropriate for job.

0356.E2.O2Transfer dimension from drawing and mark on stone using established datum points for profile set out.

0356.E2.O3Choose most appropriate dressing method for type of stone.

0356.E2.O4Carry out calculation to develop true shape for profile mould.

0356.E2.O5Set out patterns accurately for profile mould, reverse mould and bed mould to dimensions and specified shapes.

0356.E2.O6Determine allowances for fabrication processes, working off template, and transfer to bed mould.

E3Shape and profile stone.

0356.E3.O1Adjust and use power cutting tools to cut patterns for templates.

0356.E3.O2Cut template material to size minimising waste and trim to specifications.

0356.E3.O3Set up and adjust equipment and position and secure stone into place on cutting machine table ready for operation.

0356.E3.O4Set cutters and carry out initial cutting process.

0356.E3.O5Change cutters during operation to align with the profiling process.

0356.E3.O6Locate and align bed template with stone and machine operation.

0356.E3.O7Set up equipment allowing for thickness of template and gauges.

0356.E3.O8Operate equipment and accurately shape and profile stone.

E4Clean up.

0356.E4.O1Clear the work area, and dispose of, reuse or recycle materials following workplace and environmental requirements.

0356.E4.O2Clean tools and equipment, check for serviceability and report damage or faults.

0356.E4.O3Store and secure tools and equipment following workplace procedures.