Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Install prefabricated internal shopfitting units

KHU-CON-0580

Australian Equivalent

CPCSHP3007

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to receive, position and install prefabricated shopfitting units. It includes assembling large units delivered to the worksite in sections. It applies to shopfitters responsible for installing internal shopfitting units onsite concurrently with other shopfitting work that must be scheduled to accommodate client requirements, the shop when it is operational, and the requirements of other shopfitters and associated contractors. Individuals at this level take responsibility for organising and completing these tasks with a high degree of self-direction. Licensing, legislative or certification requirements may apply to this unit of competency in some states and territories. Relevant state and territory regulatory authorities should be consulted to confirm those requirements. Completion of the general construction induction tr

Elements & Learning Outcomes

E1Plan and prepare to install prefabricated internal shopfitting units.

0580.E1.O1Read and interpret plans and specifications to confirm job requirements.

0580.E1.O2Interpret and apply organisational quality assurance requirements appropriate for the project.

0580.E1.O3Receive and check delivered materials for completeness and conformity with job requirements and identify and report any damage.

0580.E1.O4Unload delivered internal shopfitting units, place in safe area onsite ready for installation, and protect unit finishes from damage.

0580.E1.O5Determine job priorities and sequence job tasks in consultation with others in the workplace.

0580.E1.O6Inspect workplace conditions, identify and report hazards, and implement risk control measures.

0580.E1.O7Select, fit and use personal protective equipment (PPE) required for the task.

0580.E1.O8Select tools and equipment and check for serviceability.

0580.E1.O9Conduct a pre-start check and rectify and report faults.

E2Check location of units and prepare for installation.

0580.E2.O1Set out and mark position for installation, strike datum to check level, and plumb and confirm with original site measurements.

0580.E2.O2Remove protrusions, install structural elements required to support the shopfitting unit and prepare positon for unit installation.

0580.E2.O3Level and plumb irregularities to meet job requirements and record any discrepancies.

E3Assemble and fix shopfitting unit.

0580.E3.O1Assemble large unit components in a position for ease of installation.

0580.E3.O2Check overall measurements of assembled unit against specification and address any anomalies.

0580.E3.O3Prepare shopfitting units with drilled holes and check fixings are appropriate to connect to brickwork, timber, metal and stone surfaces.

0580.E3.O4Install assembled unit and pack level, plumb and square using appropriate levelling equipment and process.

0580.E3.O5Anchor assembly at drilled connecting points, fit and align doors with specified parallel gaps.

0580.E3.O6Scribe and fix beading and apply sealants to meet job requirements and specifications.

0580.E3.O7Remove excessive sealant, protective covering and masking tape, and clean marks and markings from unit.

E4Clean up.

0580.E4.O1Clear work area, and dispose of, reuse or recycle materials following workplace and environmental requirements.

0580.E4.O2Clean tools and equipment, check for serviceability and report damage or faults.

0580.E4.O3Store and secure tools and equipment following workplace procedures.