Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Construct ceiling frames

KHU-CON-0109

Australian Equivalent

CPCCCA3005

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to plan, prepare, set-out, construct and erect timber ceiling frames to accommodate ceiling joists, hanging beams, strutting beams, combined hanging/strutting beams, and combined strutting/counter beams, meeting all relevant requirements of the National Construction Code (NCC), Australian Standards, work health and safety (WHS), and Commonwealth and state or territory legislation. The unit includes selection of members and setting out of ceiling frames in conjunction with roof members. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification re

Elements & Learning Outcomes

E1Plan and prepare.

0109.E1.O1Read and interpret work instructions and plan sequence of work.

0109.E1.O2Plan all work to comply with laws and regulations, the National Construction Code (NCC), Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, workplace requirements, drawings and specifications.

0109.E1.O3Select tools and equipment, check for serviceability and report any faults.

0109.E1.O4Select and use personal protective equipment (PPE) for each part of the task.

0109.E1.O5Inspect work site, locate services, assess hazards and apply risk controls, including required signage and barricades.

0109.E1.O6Select ceiling frame materials required for task, calculate quantities, handle safely and prepare and position ready for use.

E2Set out ceiling.

0109.E2.O1Identify rafter positions for roof type and set out on top plates to determine ceiling joist positions.

0109.E2.O2Set out location of ceiling joists on the top plate to specifications and spacing requirements of ceiling lining.

0109.E2.O3Design and set out for ceiling joist support members to meet the requirements of AS 1684 Residential timber-framed construction.

0109.E2.O4Cut and install ceiling joists, trimmers, hanging beams, counter beams, strutting beams and combinations of these components as per AS 1684.

E3Clean up.

0109.E3.O1Clean up, meeting all legislative and workplace requirements for safety, waste disposal and materials handling.

0109.E3.O2Check, maintain and store tools and equipment and report any faults.