Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Construct advanced roofs

KHU-CON-0113

Australian Equivalent

CPCCCA3009

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to plan, prepare, set out and construct pitched roofs on irregular plan building shapes, meeting all relevant requirements of the National Construction Code (NCC), Australian Standards, work health and safety (WHS), and Commonwealth and state or territory legislation. The unit includes gable, hip, hip and valley, or combinations of these in roofs that are applied to different types and styles of buildings. The roofs may have skewed, splayed or octagonal ends, may contain two separate roof pitches in the one structure, and have varying eave widths. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets

Elements & Learning Outcomes

E1Plan and prepare.

0113.E1.O1Read and interpret work instructions and plan sequence of work.

0113.E1.O2Plan all work to comply with laws and regulations, the National Construction Code (NCC), Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, workplace requirements, drawings and specifications.

0113.E1.O3Select tools and equipment, check for serviceability and report any faults.

0113.E1.O4Select and use personal protective equipment (PPE) for each part of the task.

0113.E1.O5Inspect work site, locate services, assess hazards and apply risk controls, including required signage and barricades.

0113.E1.O6Select materials required for task, calculate quantities, handle safely and prepare and position ready for use.

E2Set out, prepare and erect roof members.

0113.E2.O1Set out and check position of members on top of plates.

0113.E2.O2Determine bevels for all roof members.

0113.E2.O3Set out pattern rafter and cut to length allowing for overhang.

0113.E2.O4Mark main ridge boards and cut to length.

0113.E2.O5Cut common rafters to length.

0113.E2.O6Erect common rafters in sequence.

0113.E2.O7Calculate length of hip and valley rafters.

0113.E2.O8Cut and fix hip and valley rafters.

0113.E2.O9Cut and fix creeper rafters allowing for overhang.

E3Install roof support.

0113.E3.O1Determine lengths for under purlins.

0113.E3.O2Cut and install under purlins.

0113.E3.O3Measure, cut and install struts to under purlins, hips, valleys and ridges.

0113.E3.O4Install collar ties and tie-downs to span tables in AS 1684 Residential timber-framed construction.

0113.E3.O5Fit trimmers to gable ends to take gable end rafter and barge board.

0113.E3.O6Cut and fix valley boards.

E4Clean up.

0113.E4.O1Clean up, meeting all legislative and workplace requirements for safety, waste disposal and materials handling.

0113.E4.O2Check, maintain and store tools and equipment and report any faults.