Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Construct, erect and dismantle formwork for stairs and ramps

KHU-CON-0120

Australian Equivalent

CPCCCA3018

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to construct, erect and dismantle formwork for stairs and ramps to provide access between floors and landings, meeting all relevant requirements of the National Construction Code (NCC), Australian Standards, work health and safety (WHS), and Commonwealth and state or territory legislation. It includes: establishing required levels on site constructing timber, metal or prefabricated formwork to contain wet poured concrete until it is completely cured stripping the formwork preparing and storing formwork for re-use. Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, le

Elements & Learning Outcomes

E1Plan and prepare.

0120.E1.O1Read and interpret work instructions and plan sequence of work.

0120.E1.O2Plan all work to comply with laws and regulations, the National Construction Code (NCC), Australian Standards, work health and safety (WHS) and environmental requirements, manufacturers’ specifications, workplace requirements, drawings and specifications.

0120.E1.O3Select tools and equipment, check for serviceability and report any faults.

0120.E1.O4Select and use personal protective equipment (PPE) for each part of the task.

0120.E1.O5Inspect work site, locate services, assess hazards and apply risk controls, including required signage and barricades.

0120.E1.O6Select materials required for task, calculate quantities, handle safely and prepare and position ready for use.

E2Set out formwork.

0120.E2.O1Check formwork location for accuracy against plans and specifications.

0120.E2.O2Check design of stairs or ramp and method of joining formwork, and determine levels from drawings, specifications and site inspection.

0120.E2.O3Determine rise, going and pitch of stairs and ramp from drawings, specifications, site inspection, rise measurements, and requirements of the National Construction Code (NCC).

0120.E2.O4Calculate full size of stairs or ramp and set out.

0120.E2.O5Set out materials for formwork, including stringer form, to pitch of stairs with rises not exceeding specified space between treads.

E3Assemble and erect formwork.

0120.E3.O1Place, fix and brace landing bearers and joists.

0120.E3.O2Erect and brace stairs or ramp formwork soffit.

0120.E3.O3Cut, install and brace formwork for stringers.

0120.E3.O4Locate and fix formwork stringers for stairs and ramps.

0120.E3.O5Set out, cut square to length, and fix material for face of treads.

0120.E3.O6Brace risers at mid-span to prevent deflection under the load of wet concrete.

E4Strip formwork.

0120.E4.O1Strip formwork and bracing sequentially and safely.

0120.E4.O2Check formwork for reusability and dispose of damaged components.

0120.E4.O3Safely de-nail, clean, oil and store or stack reusable formwork components.

E5Clean up.

0120.E5.O1Clean up, meeting all legislative and workplace requirements for safety, waste disposal and materials handling.

0120.E5.O2Check, maintain and store tools and equipment and report any faults.