Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Carry out multistrand post-tensioning

KHU-CON-0300

Australian Equivalent

CPCCSF3003

Elements

Learning Outcomes

This unit specifies the skills and knowledge required to carry out multistrand post-tensioning in accordance with specifications. It includes planning and preparing for the work, laying and fixing anchorages and cables, defining the work area, stressing tendons, finishing tensioning and cleaning up. It applies to workers carrying out multistrand post-tensioning for a construction project, and who would be expected to take responsibility for organising and completing these tasks with a high degree of self direction. Completion of the general construction induction training program, specified in the Safe Work Australia model Code of Practice: Construction Work , is required by anyone carrying out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements apply to this unit

Elements & Learning Outcomes

E1Plan and prepare to carry out multistrand post-tensioning.

0300.E1.O1Interpret work order and associated documentation and clarify requirements with relevant persons.

0300.E1.O2Plan all work to comply with relevant legislation, regulations, standards, codes, work health and safety (WHS), environmental and workplace requirements.

0300.E1.O3Select tools and equipment required for work tasks, check for serviceability and rectify or report identified faults.

0300.E1.O4Calculate materials quantities and curing requirements.

0300.E1.O5Obtain, prepare and safely handle materials for the task, and situate them ready for use.

0300.E1.O6Erect required safety signage and barricades and fit personal protective equipment (PPE).

E2Lay and fix anchorages and cables.

0300.E2.O1Fix tendons and recess formers in location in accordance with job drawings.

0300.E2.O2Lay ducting profile, push through specified number of strands and verify in accordance with job drawings.

0300.E2.O3Position profile anchorages in accordance with specifications.

0300.E2.O4Position form head and anchorages in accordance with specifications.

0300.E2.O5Inspect installed cables in accordance with specifications and relevant standards.

0300.E2.O6Fix grout tubes in accordance with manufacturer requirements and engineering specifications.

0300.E2.O7Monitor grout tubes during concrete pour.

E3Define work area for multistrand post-tensioning.

0300.E3.O1After suitable curing time, define safe working area in accordance with WHS and regulatory requirements.

0300.E3.O2Erect barricades and signage as required to isolate safe work areas.

E4Stress tendons.

0300.E4.O1Remove recess formers.

0300.E4.O2Set up anchor blocks and wedges in accordance with manufacturer design.

0300.E4.O3Carry out stressing operations to nominated loads in accordance with engineering standards using authorised calibrated stressing equipment.

0300.E4.O4Measure extensions and record on standard forms for approval by engineer.

E5Finish tensioning.

0300.E5.O1Cut and seal protruding strands in accordance with manufacturer requirements.

0300.E5.O2Mix cement grout and pump in accordance with specifications and relevant standards.

E6Clean up.

0300.E6.O1Clear work area and dispose of, reuse or recycle materials in accordance with regulatory and workplace requirements.

0300.E6.O2Clean, check, maintain and store tools and equipment in accordance with manufacturer and workplace requirements.