Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Carry out stressbar post-tensioning

KHU-CON-0301

Australian Equivalent

CPCCSF3004

Elements

Learning Outcomes

This unit specifies the skills and knowledge required to carry out stressbar post-tensioning in accordance with specifications. It includes planning and preparing for the work; placing and inspecting bars, components and ducts; defining the work area; stressing bars; finishing the tensioning; and cleaning up. It applies to workers carrying out stressbar post-tensioning for a construction project, and who would be expected to take responsibility for organising and completing these tasks with a high degree of self direction. Completion of the general construction induction training program, specified in the Safe Work Australia model Code of Practice: Construction Work , is required by anyone carrying out construction work. Achievement of CPCWHS1001 Prepare to work safely in the construction industry meets this requirement. No licensing, legislative or certification requirements apply to th

Elements & Learning Outcomes

E1Plan and prepare to carry out stressbar post-tensioning.

0301.E1.O1Interpret work order and associated documentation and clarify requirements with relevant persons.

0301.E1.O2Plan all work to comply with relevant legislation, regulations, standards, codes, work health and safety (WHS), environmental and workplace requirements.

0301.E1.O3Select tools and equipment required for work tasks, check for serviceability and rectify or report identified faults.

0301.E1.O4Calculate materials quantities and curing requirements.

0301.E1.O5Obtain, prepare and safely handle materials for the task, and situate them ready for use.

0301.E1.O6Erect required safety signage and barricades and fit personal protective equipment (PPE).

E2Place and inspect bar, fit components and seal ducts.

0301.E2.O1Place bar and fit components in accordance with manufacturer requirements and task specifications.

0301.E2.O2Inspect bar layout for compliance with task specifications and relevant standards.

0301.E2.O3Seal ducts in accordance with manufacturer requirements.

E3Define work area for stressbar post-tensioning.

0301.E3.O1After suitable curing time, define safe working area in accordance with WHS and regulatory requirements.

0301.E3.O2Erect barricades and signage as required to isolate safe work areas.

E4Stress bars.

0301.E4.O1Place stressing jack and accessories and carry out stressing in accordance with manufacturer requirements and engineering specifications.

0301.E4.O2Tighten and lock off nuts during stressing procedure in accordance with normal stressing safety standards.

0301.E4.O3Measure extensions and record on standard quality assurance forms for approval by engineer.

E5Finish tensioning.

0301.E5.O1Seal anchorages to prevent grout loss.

0301.E5.O2Mix cement grout and pump in accordance with specifications and relevant standards.

E6Clean up.

0301.E6.O1Clear work area and dispose of, reuse or recycle materials in accordance with regulatory and workplace requirements.

0301.E6.O2Clean, check, maintain and store tools and equipment in accordance with manufacturer and workplace requirements.