Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Prepare a scope of works for remedial waterproofing

KHU-CON-0401

Australian Equivalent

CPCCWP5005

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to prepare a report for remedial scoping requirements as a result of the diagnosis of cause of water and moisture ingress in construction. The unit applies to Class 1 and 10 Buildings, and Class 2 to 9 Buildings. The unit covers planning and preparing to develop a scope of works, developing the scope and specifications, and documenting the scope of works and specifications. The unit is suitable for builders, building supervisors, building surveyors, building designers, architects, waterproofing design specialists, waterproofing supervisors, and consultants, engineers or other design specialists. Licensing, legislative, regulatory or certification requirements may apply to this unit. Relevant work health and safety (WHS) state and territory regulatory authorities should be consulted to confirm jurisdictional requirements.

Elements & Learning Outcomes

E1Plan and prepare.

0401.E1.O1Review design specifications and water ingress report, including drawings, building and structures.

0401.E1.O2Confirm stakeholder’s design brief and expectations, including timelines, finishes, systems and warranty.

0401.E1.O3Confirm relevant regulatory requirements.

0401.E1.O4Liaise with other specialist consultants, including engineers, building surveyors and local councils.

E2Develop scope and specifications.

0401.E2.O1Determine extent of the scope of works, including site conditions, demolition, occupant use, safety, specifications and quality assurance.

0401.E2.O2Develop waterproofing design in line with design brief.

0401.E2.O3Consult with product manufacturers and research appropriate systems in line with design brief.

0401.E2.O4Confirm effectiveness of waterproofing design for compliance and suitability with site conditions in accordance with National Construction Code (NCC) performance requirements, Australian Standards and manufacturers’ requirements.

E3Document scope of works and specifications.

0401.E3.O1Write scope of works to include establishment of site, roles and responsibilities, safety, stages, statutory requirements and site hand-over.

0401.E3.O2Document the system specifications in accordance with manufacturers’ requirements.

0401.E3.O3Document hold points and other quality assurance requirements.

0401.E3.O4Communicate scope of works and specifications to stakeholders.