Cambodian Skills Delivery Model

SEAL National Course Catalogue · MLVT / National Training Board

Sector Frameworks

1,164

Qualifications

15,161

Competency Units

10,938

Elements

41,782

Learning Outcomes

2,822

Assessment Packages

Survey waterproofing systems

KHU-CON-0402

Australian Equivalent

CPCCWP5006

Elements

Learning Outcomes

This unit of competency specifies the skills and knowledge required to conduct a survey of waterproofing systems and remedial recommendations for buildings. The unit applies to Class 1 and 10 Buildings, and Class 2 to 9 Buildings. The unit covers planning and preparing to conduct a survey of waterproofing systems, carrying out the survey of waterproofing systems, analysing report findings and making recommendations, and evaluating and communicating survey findings. The unit is suitable for builders, building supervisors, building surveyors, building designers, architects, waterproofing design specialists, waterproofing supervisors, and consultants, engineers or other design specialists. Licensing, legislative, regulatory or certification requirements may apply to this unit. Relevant work health and safety (WHS) state and territory regulatory authorities should be consulted to confirm jur

Elements & Learning Outcomes

E1Plan and prepare.

0402.E1.O1Determine scope of survey in consultation with stakeholders, reports and project brief, building works or structural specifications.

0402.E1.O2Gather and review design specifications and data sheets, manufacturers’ information, drawings and waterproofing contractors’ scopes of work.

0402.E1.O3Assess site environmental conditions according to approved plans, including surface and sub-surface drainage.

0402.E1.O4Confirm design complies with National Construction Code (NCC) performance requirements and Australian Standards.

0402.E1.O5Determine tools, equipment and relevant technologies required for the survey according to site conditions.

0402.E1.O6Develop the scope for the survey, including installation stages and compliance review.

E2Carry out survey.

0402.E2.O1Establish stage inspection protocols and benchmarks for compliance with design and manufacturers’ specifications.

0402.E2.O2Communicate survey procedures and timeframe in consultation with stakeholders.

0402.E2.O3Conduct quality assurance inspections of the waterproofing systems, including substrate assessment for suitability, component installation and compliance with manufacturers’ specifications.

0402.E2.O4Identify latent conditions outside of the waterproofing system design.

0402.E2.O5Determine if installation complies with design requirements and manufacturers’ specifications.

0402.E2.O6Record observations of survey of waterproofing systems for analysis.

E3Analyse survey report findings and make recommendations.

0402.E3.O1Review report findings and confirm installation complies with manufacturer’s specifications, Australian Standards and NCC performance requirements.

0402.E3.O2Identify and document any non-compliance regarding installation and deviation from design.

0402.E3.O3Develop recommendations for remediation of non-compliances and any defects.

0402.E3.O4Develop recommendations to remediate the latent conditions to assist with the remediation advice.

0402.E3.O5Develop a report summary and quality control recommendations for stakeholders.

E4Evaluate survey findings and communicate recommendations.

0402.E4.O1Review survey findings against waterproofing systems design.

0402.E4.O2Review and confirm remediation of non-compliances and defects, including latent conditions.

0402.E4.O3Review survey results to accommodate use of area at the highest risk level.

0402.E4.O4Communicate survey findings and any recommendations to stakeholders.